← All projects

Thermal experiments · Group 5

Heat Transfer: Conduction & Convection

Compared thermal models with group experiments in metal-rod conduction, thermochromic temperature mapping, pin-fin cooling, transient response, and forced convection.

Past projectSummer 2026 · Three laboratory studies

Group 5 · Three collaborative heat-transfer laboratory reports · Summer 2026

Threaded-rod conduction apparatus with heater, aluminum blocks, ice cup, and temperature logger
Metal-rod conductivity apparatus from Group 5’s 1-D Conduction report, figure 1.

My contribution

I contributed to Group 5’s heat-transfer work and collaborative reports, including my metal-rod conductivity measurements. Our collection combines experimental temperature histories with MATLAB analysis, energy balances, analytical temperature fields, and convection correlations. We compared results across the group to examine how setup and measurement choices affected the predictions.

Results & observations

The experiments exposed how heat losses, surface contact, geometry, and boundary conditions affect thermal predictions. In the group’s forced-convection study, mean steady-state flat-plate coefficients increased from about 27.0 to 32.5 W/(m²·K) across three fan settings. The pin-fin fit and conductivity estimates showed substantial discrepancies, providing concrete limits on the models.

Lab 1 · Measuring metal-rod conductivity

We compared stainless steel, brass, and aluminum using a heated base, threaded rod, and ice-cooled top. Two heat-rate estimates produced substantially different conductivity values. My measurements are included in the team tables; the group comparison showed why heater electrical input cannot simply be assumed to equal heat conducted through the rod.

Lab 2 · Temperature fields and contact resistance

A thermochromic PLA specimen made the heating pattern visible as its color changed near 45 °C. Flipping the contact surface changed where heating appeared first. We compared the observed pattern with an analytical two-dimensional temperature field, using the color transition as qualitative evidence rather than a precise temperature map.

Lab 2 · Fins and transient cooling

We compared measured temperature profiles along brass and aluminum pin fins with fin theory, then fitted an ice-bath cooling history to a lumped-capacitance model in MATLAB. The pin-fin fit returned an implausibly large air-side convection coefficient. The result pointed to problems with the assumed geometry or model, despite the numerical fit.

Lab 3 · Forced convection over plates and cylinders

The group compared three fan settings using flat-plate temperature histories and ice-melt timing around a cylindrical container. Warm-up slopes estimated net heating; steady-state and cooling data supplied independent convection estimates. For the cylinder, a background control was subtracted before comparing results with the Churchill–Bernstein correlation.

Comparing the models with the apparatus

Mean steady-state flat-plate coefficients were approximately 27.0, 29.4, and 32.5 W/(m²·K), compared with theoretical values of 28.5, 31.1, and 33.1. Cylinder results showed larger discrepancies and variation between experimenters. Our discussion proposed better airflow alignment and more consistent positioning.

Tools & methods

  • Heat conduction
  • Forced convection
  • MATLAB
  • Energy balances
  • Thermal conductivity
  • Pin-fin analysis
  • Lumped capacitance
  • Temperature measurement
  • Curve fitting
  • Model assessment